Answering the question: how is the air conditioner installed? It should be said right away that installation cannot be mastered alone. I need an assistant. This is a long and painstaking business. Requires special skills, knowledge and equipment (watch the video on how to install the air conditioner yourself).
What tools are needed?
- perforator with a set of drills;
- screwdriver, knife;
- level;
- adjustable wrench;
- Vacuum pump;
- rolling (see the photo on how to install air conditioners);
- pipe cutter;
- brackets;
- copper pipe for the route (see the instructions for the diameter);
- thermal insulation for pipes;
- plastic tube for drainage.
Indoor unit installation
Installation begins with the installation of the indoor module. It is more convenient to mount it on the outer wall or as close to it as possible, going down from the ceiling by 25 - 30 centimeters.
The first step in installing the air conditioner is fixing the metal frame to the wall. Be sure to level it. The box must be hung at a slope of 5 mm per meter towards the street so that the drainage can flow down.
Before you install the air conditioner yourself, two holes are drilled out into the street for laying the copper pipe and drainage, also at an angle. They are dragged along with the electric cable.
Outdoor unit installation
Places for brackets are marked under the level. As a rule, this is done from the window, you can use climbing equipment (see the video on how to install air conditioners). Once the unit is installed, it is immediately screwed on and connected. It is very heavy. Bolts for fastening are included, washers are installed on both sides.
Assembling the track
For those who are only interested in the question: how the air conditioner is installed, you do not need to read further. Now the most difficult thing is laying the route.
The indoor unit is connected first. A nut is put on a cleanly cut tube, plugs are removed and the tube is rolled. It should protrude by 2 millimeters - this is the secret of perfect rolling, which can be seen in the photo how to install the air conditioner. Then the nut is screwed on, very tightly and everything is repeated with the outdoor unit. Physically, it is difficult, because the procedures are carried out on weight. Watch the whole process on the video how to install the air conditioner yourself.
Route evacuation
We attach the pump tube to the filling port and evacuate it (watch the video on how to install the air conditioner). Do not open ports! The duration of the procedure is 15 - 30 minutes to draw out all water vapor.
At the end of the evacuation, the valve is closed, but the pump is not disconnected. It is necessary to hold it for another quarter of an hour. If during this time the arrow does not change position, it means that the track is assembled well and there are no leaks, it was possible to mount it without errors.
The start of the air conditioner must be carried out by a master from the service center. Failure to do so will void the warranty.
